AMG polyphosphate dispensers

AMG polyphosphate dispensers

AMG dispensers have been produced in Italy since 1970, the leaders of the European market. Scope of application, protection of heating elements from scale and corrosion. They are installed on the cold water supply line before the secondary heat exchanger of the gas wall-mounted boiler, indirect heating boiler, washing machines and dishwashers. The device effectively suppresses descaling, one cartridge is enough for 15,000 liters or 2-2. 5 months of operation for a family of three people. Thanks to the Venturi metered recharge system, the device can be used on drinking water in accordance with the EU Directive 98/83 CE. The operating temperature of the solution is 80°C, in contrast to granulated polyphosphate for washing machines, with an operating temperature of 40-45°C.

The device is made of high-quality PPSU plastic (like REHAU fittings), is not subject to corrosion, strength characteristics: 8 bar working pressure, 40 bar test. Fully serviced housing with vertical and horizontal installation. The design includes an overlapping gate valve, the device can be installed without overlapping taps directly into the main line. The connection size is 90 mm. Connection method-1/2 " brass cap nuts. The design also provides a drain valve.

Economic justification: the cost of the device is comparable to calling the service to flush the heat exchanger. When using the device on hard water, heat exchangers and heating elements often fail, this case is not guaranteed and leads to the cost of replacing the heating elements. The cost of components can range from 5,000 to 11,000 rubles, excluding the cost of work. The use of a polyphosphate dispenser extends the life without emergency operation and saves up to 30% of the energy consumption of the heating element.

TD Stroyservice is the exclusive representative of the AMG brand on the territory of the Russian Federation.

The polyphosphate gel dispenser is a widely used solution for heating systems.

The product is made in Italy. It has been supplied to the Russian market for more than 10 years. The case is made of Nickel-plated brass. The design has a shut-off valve and a drain valve. Similar in physical properties to AMG dispensers. The design has a cap nut element that presses the flask to the body, tightening is carried out with a special key included in the delivery set.

TD Stroyservice is a dealer of the Gel brand.